2010年5月31日 星期一

Final_Moire_Wall ( Arduino Mega + Light_Sensor + Servo + HumanHands )


6 Video Inside

這篇主要為成果的影片
並略加簡易說明
this is the Final project of the Moire_Wall
the video and texts give the brief introduction
of this project


Moire_Wall With Flash_Light

利用光敏電阻的值 控制Servo旋轉之角度
當值大過某定量時 開始旋轉
旋轉角度與感測值成正比
We use the value which is from the
photovaristor to control the rotation
of the servo motors


Moire_Wall With HumanHands

在程式中改寫
此刻需要使光敏電阻小於某定值時
才開始旋轉
因此當手經過時
墨爾紋開始旋轉
In the program, we set up an If-Else condition,
when the value of the photovaristor is
smaller then certain number
the Moire pattern start to rotate.
While the hands make the shadow on the photovaristor,
it starts to rotate.

Moire_Wall With Fluorescent _Light Tube

與第一個同理 有光線經過即造成旋轉
same concept from the first one,
but this time we use light to control the rotation

Moire_Wall With Shadows

與第二影片同理
只要遮蔽光敏電阻
影子亦可造成影響
The same concept as the second video
the shadow could control the
rotaition of the Moire_Pattern

Moire_Wall With Processing

此刻加入Processing
Processing所畫之墨爾紋
同樣利用光敏電阻感知之數值
決定電腦中墨爾紋旋轉角度
再將其用Projector
投射到作品中
產生更暈眩之感覺
Projecting the Moire_Pattern
we program by Processing
to make the variety of the color

此為投影之後的效果
依然可以與人作互動
this video shows the result with the pattern
project on the installation.
the project could interact with people
in this kind of condition 

製作過程請參看

see the process here


沒有留言:

張貼留言